Skip to Content
Last modified by Erik Bakker on 2024/09/27 14:07
From version 28.21
edited by Danniar Firdausy
on 2024/09/25 13:36
Change comment: There is no comment for this version
To version 28.22
edited by Danniar Firdausy
on 2024/09/25 13:40
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -18,7 +18,7 @@
18 18  
19 19  == 3.1 Settings ==
20 20  
21 -After finishing up your configuration in the Design phase, you can then go to the Settings page on the top right corner of the Create phase. In this page, as shown below, you will find .
21 +After finishing up your configuration in the Design phase, you can then go to the Settings page on the top right corner of the Create phase. In this page, under the "Failover systems" tab in the "Transfer settings from design" section, you will find the system connector(s) that you can transfer the failover settings from Design.
22 22  
23 23  [[image:Main.Images.Microlearning.WebHome@grouping-and-failover--intermediate-grouping-and-failover-setting-up-failover-create-phase-create-settings.png]]
24 24