Skip to Content
Last modified by Erik Bakker on 2024/09/27 14:07
From version 28.62
edited by Danniar Firdausy
on 2024/09/25 16:05
Change comment: There is no comment for this version
To version 28.63
edited by Danniar Firdausy
on 2024/09/25 16:05
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -14,9 +14,9 @@
14 14  
15 15  This microlearning describes what configuration that you will have to do in the Deploy phase, based on what you have configured in the Design and Create phase, to enable failover for systems connecting with your model. The grouping and failover functionality is relevant when faced with maintenance and outages of systems connected to your model. The failover functionality assists in that case and allows you to have a fallback option on an active connection.
16 16  
17 -== 3. Create Phase Configuration ==
17 +== 3. Deploy Phase Configuration ==
18 18  
19 -== 3.1 Settings ==
19 +== 3.1 Deploy Architecture ==
20 20  
21 21  After finishing up your configuration in the Design phase, you can then go to the Settings page on the top right corner of the Create phase. In this page, under the "Failover systems" tab in the "Transfer settings from design" section, you will find the system connector(s) that you can transfer the failover settings from Design. Please check the screenshot below as an example.
22 22