Skip to Content
Last modified by Erik Bakker on 2024/09/27 14:07
From version 28.88
edited by Danniar Firdausy
on 2024/09/26 10:37
Change comment: There is no comment for this version
To version 28.86
edited by Danniar Firdausy
on 2024/09/25 21:24
Change comment: There is no comment for this version

Summary

Details

Page properties
Content
... ... @@ -38,16 +38,10 @@
38 38  
39 39  To do this, you can click the "wrench" icon on the right hand side beside the "Create phase" release and then press "New". In the pop-up presented to you, you can click the "Name" input field and then search for the property placeholder names that you saw earlier. The idea here is that you fill in the IP address and the (open) port of the external machines. Thus, based on the example above, you can search for the keyword "external01.failover.internal-ip" and then select it. Afterward, you can set this property as global for simplicity and fill in the correct value. The screenshot below shows an example of the end result. Once you have done so, then you can do the same for the other property (i.e., "external01.failover.port") and as well as the properties for the second machine.
40 40  
41 -[[image:Main.Images.Microlearning.WebHome@grouping-and-failover--intermediate-grouping-and-failover-setting-up-failover-deploy-phase-failover-properties.png]]
41 +<picture>
42 42  
43 -When you are done, then you can save your changes, and proceed with creating a new release. For this, you will need to create a new release from your "Create phase", in order to include all configurations that eMagiz has provided in your now failover-enabled Create phase. Once you have done this, give the release a name and save it, then you can proceed with activating the release and deploy it.
43 +When you are done, then you can save your changes, and proceed with creating a new release. For this, you will need to create a new release from your "Create phase", in order to include all configurations that eMagiz has provided in your now failover-enabled Create phase. Once you have done this, give the release a name and save it, then you can proceed with activating the release and deploy it.
44 44  
45 -== 3.3 Trigger Failover ==
46 -
47 -Once you have successfully deployed and run your release with the failover connector runtimes, then you can observe the follower and leadership status of your failover connector runtimes in your Deploy>Architecture. There, if you right-click your external machines (which have the failover connector runtimes) and select "Start/Stop flows", under the "Groups" tab, you will find the Group name, Failover status, as well as the state.
48 -
49 -[[image:Main.Images.Microlearning.WebHome@grouping-and-failover--intermediate-grouping-and-failover-setting-up-failover-deploy-phase-start-stop.png]]
50 -
51 51  == 4. Key takeaways ==
52 52  
53 53  ...