Skip to Content

Changes for page Failover - Configuration

Last modified by Erik Bakker on 2024/09/27 14:06
From version 30.1
edited by Danniar Firdausy
on 2024/09/27 09:25
Change comment: There is no comment for this version
To version 28.19
edited by Danniar Firdausy
on 2024/09/27 09:22
Change comment: There is no comment for this version

Summary

Details

Page properties
Title
... ... @@ -1,1 +1,1 @@
1 -Failover - Configuration
1 +Failover - Configuration - Design Phase
Content
... ... @@ -17,7 +17,7 @@
17 17  
18 18  This microlearning describes how to configure (parts of) of your Design phase to enable failover for systems connecting with your model. The grouping and failover functionality is relevant when faced with maintenance and outages of systems connected to your model. The failover functionality assists in that case and allows you to have a fallback option on an active connection.
19 19  
20 -== 3. Failover Configuration ==
20 +== 3. Design Phase Configuration ==
21 21  
22 22  == 3.1 Solution Design ==
23 23  
... ... @@ -39,14 +39,6 @@
39 39  
40 40  When you have done that and satisfied with your landscape configuration, then you are finished in the Design phase and can proceed to the next configuration in the Create phase.
41 41  
42 -== 3.3 Transfer Settings from Design ==
43 -
44 -After finishing up your configuration in the Design phase, you can then go to the Settings page on the top right corner of the Create phase. In this page, under the "Failover systems" tab in the "Transfer settings from design" section, you will find the system connector(s) that you can transfer the failover settings from Design. Please check the screenshot below as an example.
45 -
46 -[[image:Main.Images.Microlearning.WebHome@grouping-and-failover--intermediate-grouping-and-failover-setting-up-failover-create-phase-create-settings.png]]
47 -
48 -By pressing the "Transfer failover" button, eMagiz will regenerate the connector infra flow of that system as well as update the exit and entry flows connected to that system with the required settings. Thus, you do not have to configure them manually by yourself and can already proceed to the next step in the Deploy phase.
49 -
50 50  == 4. Key takeaways ==
51 51  
52 52  * The inbound components of eMagiz flows can be grouped, allowing for centralized control, particularly beneficial during system maintenance or outages.