Skip to Content

Changes for page Failover - Configuration

Last modified by Erik Bakker on 2024/09/27 14:06
From version 30.3
edited by Danniar Firdausy
on 2024/09/27 09:35
Change comment: There is no comment for this version
To version 31.1
edited by Erik Bakker
on 2024/09/27 14:05
Change comment: There is no comment for this version

Summary

Details

Page properties
Author
... ... @@ -1,1 +1,1 @@
1 -XWiki.dfirdausy
1 +XWiki.ebakker
Content
... ... @@ -19,7 +19,7 @@
19 19  
20 20  == 3. Failover Configuration ==
21 21  
22 -== 3.1 Solution Design ==
22 +=== 3.1 Solution Design ===
23 23  
24 24  To configure failover for systems that are connecting with your model, we first need to go to the Design phase. In your Design>Solution Design, find and open the details of the system that you want to enable failover for. Once you do that, then you need to make sure that "Multiple runtimes" option is selected for this system, which is logical since we want to have a second runtime running in case of failover situations (e.g., outage, maintenance, etc.). Afterward, you will see the "Number of runtimes" and "Run in failover" fields. To enable failover, make sure that you fill in 2 as the "Number of runtimes", before selecting the "Run in failover" checkbox. See the screenshot below as an example.
25 25  
... ... @@ -27,7 +27,7 @@
27 27  
28 28  {{info}}Systems with the failover option enabled must have "Number of runtimes" exactly 2 and must be placed on an external machine in the Architecture panel.{{/info}}
29 29  
30 -== 3.2 Design Architecture ==
30 +=== 3.2 Design Architecture ===
31 31  
32 32  Once the previous step is done, the next step is to configure your Design>Architecture. Here, you first need to "Start Editing" and then press "Apply settings" on your bottom left corner. Afterward, you will be faced with a pop-up page informing you that failover will be enabled on the system connector containers that you have previously toggled in Design>Solution Design (see the screenshot below as an example).
33 33  
... ... @@ -39,7 +39,7 @@
39 39  
40 40  When you have done that and satisfied with your landscape configuration, then you are finished in the Design phase and can proceed to the next configuration in the Create phase.
41 41  
42 -== 3.3 Transfer Settings from Design ==
42 +=== 3.3 Transfer Settings from Design ===
43 43  
44 44  After finishing up your configuration in the Design phase, you can then go to the Settings page on the top right corner of the Create phase. In this page, under the "Failover systems" tab in the "Transfer settings from design" section, you will find the system connector(s) that you can transfer the failover settings from Design. Please check the screenshot below as an example.
45 45